Pocket hole screw size for 3/4" material
Three-quarter-inch is the workhorse thickness for pocket holes — 3/4" plywood and nominal 1× lumber are what most cabinets and furniture are built from, so this is the size most people are actually asking about.
Here's the pocket-hole screw length for 3/4" material, and the thread to match your wood.
Material thickness
Change the thickness to see other lengths — use the actual thickness of your stock.
Pocket screw for 3/4" material
Thread — coarse for softwood & plywood, fine for hardwood & MDF.
Get the gear
As an Amazon Associate, WhatDrillBit earns from qualifying purchases.
What 3/4" stock is for
3/4" stock is the default for cabinet boxes and face frames, bookshelves and shelving, table and bench aprons, and most furniture carcasses — anything built from 3/4" plywood or nominal 1× boards.
It's the thickness the standard jig setting and the common pocket screw length are designed around, which is why it's the most forgiving thickness to start with.
Using a Kreg jig?
Set the drill guide to your material thickness. For the exact depth mark on your specific jig, check Kreg’s official screw-selector chart — the settings vary by jig model.
Common questions
What length pocket hole screw for 3/4" material?
For 3/4" (19 mm) stock, use a 1¼" (32 mm) pocket screw. Pocket-hole screw length is set by the thickness of the piece the pockets are drilled in.
Coarse or fine thread for 3/4" material?
Match the thread to the material: coarse-thread pocket screws for softwood and plywood, fine-thread for hardwood and MDF.
Do pocket hole screws need a pilot hole in 3/4" stock?
No — pocket screws are self-tapping, and the jig's stepped bit drills the pilot in the first board. Just set the jig and the drill-guide collar for 3/4" material.
Full pocket-hole screw chart
Pocket hole screw size chart
| Material thickness | Pocket screw length |
|---|---|
| ½"12 mm | ¾"19 mm |
| ⅝"16 mm | 1"25 mm |
| ¾"19 mm | 1¼"32 mm |
| ⅞"22 mm | 1½"38 mm |
| 1"25 mm | 1½"38 mm |
| 1⅛"29 mm | 1½"38 mm |
| 1¼"32 mm | 2"51 mm |
| 1⅜"35 mm | 2"51 mm |
| 1½"38 mm | 2½"64 mm |
Thread: Softwood / Plywood — coarse · Hardwood / MDF — fine. Match the thread to the material the screw drives into. Use the actual thickness of your stock, not the nominal size.
whatdrillbit.com
Where these numbers come from
Pocket-hole screw length is set by the actual thickness of the board the pockets are drilled in — standard pocket-hole practice, cross-referenced against Kreg’s published guidance. Thread follows the receiving material: coarse for softwood and plywood, fine for hardwood and MDF. The exact drill-guide depth setting is proprietary to your jig, so for that we defer to Kreg’s official screw-selector chart rather than reproduce it here.
These are general guidance sizes cross-referenced from common woodworking sources. For structural, load-bearing, or manufacturer-specific work, follow the fastener manufacturer’s or an engineer’s specifications.